Powerplus POWAIR0310 PNEUMATIC STAPLER/NAILER EN - Manual (Page 7)

POWAIR0310 EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
aw (Vibration) 4.6 m/s² K = 0.02 m/s²
12 TROUBLESHOOTING
SYMPTOM PROBLEM SOLUTIONS
Air leak
near top of tool or in
trigger area O-ring in trigger valve is
damaged. Check and replace O-ring.
Trigger valve head are
damage. Check and replace.
Trigger valve stem, seal or
O-ring are damaged. Check and replace trigger
valve stem, seal or O-ring
Air leak near bottom of
tool. Loose screws. Tighten screws.
Worn or damaged O-rings or
bumper. Check and replace O-rings
or bumper.
Air leak between body
and cylinder cap. Loose screws. Tighten screw.
Worn or damaged O-rings or
seals. Check and replace O-rings
or bumper.
Blade driving fastener
too deep. Worn bumper. Replace bumper.
Air pressure is too high. Adjust the air pressure.
Tool does not operate
well: can not drive
fastener or operate
sluggishly. Inadequate air supply. Verify adequate air supply.
Inadequate lubrication. Place 2 or 6 drops of oil into
air inlet.
Worn or damaged O-rings or
seals. Check and replace O-rings
or seal.
Exhaust port in cylinder head
is blocked. Replace damaged internal
parts.
Tool skips fasteners. Worn bumper or damaged
spring. Replace bumper or pusher
spring.
Dirt in front plate. Clean drive channel on front
plate.
Dirt or damage prevents
fasteners from moving freely
in magazine. Magazine needs to be
cleaned.
Worn or dry O-ring on piston
or lack of Lubrication. O-ring needs to be replaced
and lubricate.
Cylinder covers seal leaking. Replace Sealing washer.
Tool jams. Incorrect or damaged
fasteners. Change and use correct
fastener.
Damaged or worn driver
guide. Check and replace the
driver.