Powerplus POWAIR0020 PNEUMATIC TOOL SET 5PCS EN - Manual (Page 4)

POWAIR0020 EN
Copyright © 2015 VARO P a g e | 4 www.varo.com
Use Method of use Recommended
Pressure
Painting Connect the compressed air supply to fitting C. Check if
the spray gun is actually working efficiently before you fill
the container (spray air through the tool). Mix the paint in
a separate container and then pour it into container B, up
to roughly 2/3 of its total capacity. Stand roughly 20-30
cm away from the surface to be painted, press the trigger
and direct the jet over the surface. Move the spray gun in
parallel strokes compared to the surface to be painted,
keeping it at a right angle. You can adjust the flow of
liquid by adjusting knob A and the amplitude of the jet by
adjusting knob F.
Some helpful tips: make sure that the surface to be
painted is perfectly clean and dry. To ensure an even
finish, start the stroke before you actually press the
trigger and continue the stroke after the trigger has been
released. Never stop on one point while the trigger is
pressed. Always thoroughly clean container B and the
tool at the end of the job using special solvents. 1,5 – 3,5 bar
(depending on
paint density)
3.3 Blow gun
Use
Method of use Recommended
Pressure
Blowing Connect the compressed air supply to fitting C. Press the
trigger and direct the jet over the surface to be blown. Adjust the
pressure
according to
need
WARNING! Wear eye protection! Air blast can cause debris and dust to be
blown back towards you.
3.4 Inflation gun
Use
Method of use Recommended
Pressure
Inflation Connect the compressed air supply to fitting C. Connect
the inflation fitting D to the valve of the wheel and check
the pressure on gauge E. Press the trigger to inflate and
keep checking the pressure on the gauge: if the pressure
is too high, push button F to restore the correct pressure. 4 bar
4 MAINTENANCE
4.1 Spray gun

Pour remaining paint into another container and then clean paint passage and air
cap. Spray a small amount of thinner to clean passage. Incomplete cleaning will
result the spray pattern to be un-sharp and small particles may be in the product
sprayed. Clean fully and promptly two-component paint after using.