beautypg.com

Troubleshooting, Technical data, 10 troubleshooting – Powerplus POW63754 LAWNMOWER 123CC 460MM EN User Manual

Page 12: 11 technical data

background image

POW63754

EN

Copyright © 2013 VARO

P a g e

| 12

www.varo.com

Warning: Do not touch rotating blade.

10 TROUBLESHOOTING

Problem

Probable cause

Corrective action

Engine does not
start

Fuel tank is empty.

Fill tank with fuel

Air cleaner element is dirty.

Clean air cleaner element

Spark plug loose.

Tighten spark plug to 25-30 Nm.

Spark plug wire loose or
disconnected from plug.

Install spark plug wire on spark plug.

Spark plug gap is incorrect.

Set gap between electrodes at 0.7 to 0.8mm

Spark plug is defective

Install new, correctly gapped plug

Carburetor is flooded with
fuel

Remove air cleaner element and pull starter
rope continuously until carburetor clears
itself and install air cleaner element.

Faulty ignition module

Contact the service agent.

Engine difficult
to start or loses
power.

Dirt, water, or stale fuel
tank.

Drain fuel and clean tank. Fill tank with
clean, fresh fuel

Vent hole in fuel tank cap
is plugged.

Clean or replace fuel tank cap.

Air cleaner element is dirty.

Clean air cleaner element.

Engine operates
erratically.

Spark plug is defective.

Install new, correctly gapped plug

Spark plug gap is incorrect.

Set gap between electrodes at 0.7 to 0.8mm

Air cleaner element is dirty.

Clean air cleaner element

Engine idles
poorly.

Air cleaner element is dirty.

Clean air cleaner element

Air slots in engine shroud
are blocked.

Remove debris from shots.

Cooling fins and air
passages under engine
blower housing are
blocked.

Remove debris from cooling fins and air
passages.

Engine idles
poorly.

Gap between electrodes of
spark plug is too close.

Set gap between electrodes at 0.7 to 0.8mm

Engine
overheats

Cooling air flow is
restricted.

Remover any debris from slots in shroud,
blower housing, air passages

Incorrect spark plug.

Install FGRTC spark plug and cooling fins
on engine

Mower vibrates
abnormally

Cutting assembly is loose.

Tighten blade

Cutting assembly is
unbalanced

Balance blade.

11 TECHNICAL DATA

Model

POW 63754

Power

2.6 kW

Speed at max. Power

2900min

-1

Self Propelled

Yes

clutch

yes