Eagle Electronics Eagle View - Manual (Page 8)

4
WHITE
TO
EAGLE VIEW
2-AMP
FUSE
GREEN
BLACK
RED
12-VOLT
BATTERY
EAGLE VIEW
TRANSMIT
(NMEA)
EAGLE VIEW
RECEIVE
(NMEA)
POWER
The Eagle View will operate from a 12-volt DC system. (9 to 15 volts DC.)
You can connect the power cable to an accessory buss under the dash,
however, to keep electrical noise interference to a minimum, we recom-
mend you wire the power cable directly to the battery through the sup-
plied 2-amp fuse.
CAUTION!
Do not connect this product to a power source without using a fuse!
Failure to use the fuse can cause damage to your unit and will void the
warranty.
Follow the wiring diagram below. If the wires on the power cable are not
long enough to reach the battery, use 18 gauge wire to lengthen the power
cable.
The power cable’s green wire is used to receive data from a DGPS re-
ceiver. The white wire is used to transmit data to a DGPS receiver or other
electronic equipment. If you are not connecting the Eagle View to another
device, tape the ends of these wires and secure them where they will not
short to one another. See the NMEA/DGPS section in this manual for
more information.
(Note: If your power cable has six wires, tape and secure the extra wires,
also. They are not used on this product.)