Clean motor filter, Brush roll, Cleaner care – Eureka 160 User Manual
Page 8
Clean Motor Filter
NOTE:
Turn off the power switch and unplug the electrical cord to service.
Clean the motor filter after each cleaner use.
1.
Shake and brush the dust and dirt from filter.
2. Pull back on rubber gasket to remove filter from the
frame.
3. If desired launder the filter by hand in warm water
(150°F 65°C) using a mild detergent.
4.
Air dry thoroughly.
5.
Replace filter over frame and secure the lip of the
frame into the gasket.
Replace a dirty or torn filter. Order additional motor filters from The Eureka
Company, Bloomington, IL 61701. Order motor filter, part number 37466.
Brush Roll
(optional)
NOTE: Turn off the power switch and unplug the electrical cord to service.
The brush roll turns as it sweeps and combs the carpet nap. Remove any hairs, threads
or obstructions from the brush roll area to keep the brush roll clean so it rotates properly.
Cleaner Care
NOTE: Turn off power switch and disconnect electrical cord to clean unit.
To keep the vacuum cleaner looking new, it can be wiped with a damp cloth and a mild
soap solution, then thoroughly dried. Never use any type of chemical as chemicals can
damage the cleaner.
8
Pull filter away
from frame.