How to maintain, Empty dust cup – Eureka 160 User Manual

Page 7

HOW TO MAINTAIN

The instructions in this booklet serve as a guide to routine maintenance Keep the cleaner
operating at top efficiency Empty the dust cup and clean the filter after each use.

Empty Dust Cup

Note:

Turn off the power switch and unplug the electrical cord to service.

1. Slide dust cup latch up.

2. Pull dust cup from handle section

and lift from the nozzle.

3. Grasp curve edge of motor filter

and pull out to remove.

Clean motor

filter (refer to motor filter section).

4. Shake contents of dust cup into

waste container.

5. Replace motor filter. Put flat side

into dust cup. Press curve edge
into place until the rim of motor
filter rests on ribs inside dust cup.

6. Hold dust cup sides with thumbs

near the latch.

7. Position dust cup over nozzle.

8. Wrap fingers to the back of the

handle section. Gently squeeze the
sections together until the dust cup
latch locks the cup in place.

Latch

Motor Filter