Esoteric P-03 - Manual (Page 15)

15
PROGRAM
Press to engage the program mode.
SKIP (.//)
Press to skip forward or backward during playback.
PAUSE
Press to pause playback.
RETURN
Press in the setup mode to return to a previous level in the
setup menu.
DAC OUTPUT LEVEL
Use to adjust the output level on the D/A converter D-01. Be
sure to point the remote control at the D-01 display when
using this function. (This function is not available on the D-
03.)
DVD audio operating buttons
The following buttons are used for controlling DVD-Audio
and will become available after a future upgrade.
AUDIO
Press to select audio playback during DVD-Audio playback.
GROUP
Press to skip groups during DVD-Audio playback.
S
R
Q
P
O
N
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive “+” and
negative “_” polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable or non-rechargeable batteries can be used but
not mixed together. Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they
leak, wipe away the liquid inside the battery compartment
and replace the batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
Notes on use
< Point the remote control unit at the main unit’s remote sensor
within seven meters (23 feet) of the main unit. There should
not be any obstacles between the player and the remote
control unit.
< Do not allow direct sun or other light to shine on the remote
sensor part of the main unit. This may cause the remote
control unit to work incorrectly.
< Note that other units with remote controls may operate
incorrectly because of infrared light “overspill” when you
operate this remote control unit.
How to insert the batteries
Remove the cover of the remote control unit with a
screwdriver. After checking the polarity (+/_) of two AA
batteries, insert the batteries, replace the cover and replace
the screws.
Remote Control Unit