Electrolux 44050 VI - Manual (Page 16)

Operating Instructions
16
Activating/deactivating the acoustic signal
The acoustic signal can indicate acoustically:
– at which water hardness the water softener is set.
– when a dishwashing cycle has finished.
– when an error has occurred with the dishwasher.
You can switch on/off the acoustic signal in the following way:
1. Press the ON/OFF button.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
3 If the only LED indicator illuminated is one that belongs to a pro-
gramme button, this means that this dishwashing cycle has been acti-
vated. The dishwashing cycle must be cancelled (RESET):
Press function buttons 2 and 3 simultaneously for approx. 1 second.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
2. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 3.
The LED indicator for function button 3 will flash.
The
L
display will indicate the current setting:
4. Pressing function button 3 will change the setting.
5. Once the
L
display is indicating the required setting, press the ON/
OFF button. The setting is now saved.
In Daily Use
• Check the salt and rinse aid levels.
• Load cutlery and dishes into the dishwasher
• Fill with dishwasher detergent
• Select a wash programme suitable for the cutlery and dishes
• Start the wash programme
The
L
indicator is flashing: Acoustic signal activated (ex-factory setting)
The
L
indicator is not
flashing:
Acoustic signal deactivated