Electrolux 44050 VI - Manual (Page 11)

Operating Instructions
11
Setting the water softener
Using the table as a guide, adjust the water softener to that which cor-
responds to the hardness of the water in your area:
0 The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower rack from the
dishwasher.
3. Turn the hardness range switch to 0
or 1 (see table).
4. Replace the lower rack.
Setting electronically:
5. Press the ON/OFF button.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
3 If the only LED indicator illuminated is one that belongs to a pro-
gramme button, this means that this dishwashing cycle has been acti-
vated. The dishwashing cycle must be cancelled (RESET):
Press function buttons 2 and 3 simultaneously for approx.1 second.
The LED indicators for all the buttons in the control panel that are now
able to be selected will become illuminated.
6. Press function buttons 2 and 3 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
7. Press function button 1.
The LED indicator for function button 1 will flash. The LED indicator for
the end of the dishwashing cycle is flashing and acoustic signals can be
heard simultaneously (only when the acoustic signal has been acti-
vated):
– The number of times that the LED indicator for the end of the cycle
flashes and the number of acoustic signals correspond to the new
hardness setting.
– This sequence of flashes and acoustic signals is repeated many times,
with a 5 second pause in between.
8. Pressing function button 1 increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
9. When the hardness setting is correct, press the ON/OFF switch.
The hardness setting is now saved.