Casio PX-760 - Manual (Page 39)

English
Assembling the Stand
EN-37
1.
Remove the four screws (two on each end)
from back board
C .
2.
Attach side panels A and B to back board
C . Secure side panels A and B to the back
board C using the screws you removed in
step 1.
• Attach the side panels so the side of the back panel C
where the joint connectors are inserted is facing
towards the back of the stand.
• If you have trouble inserting a screw into a joint
connector screw hole, use a screwdriver to adjust the
joint connector by rotating it.
3-1.
If you plan to locate the piano and stand
where it is not against a wall, you need to
extend the anti-tip brackets at the base of
side panels
A and B . Remove the two
screws (one on the outside of each side
panel) that hold the brackets, and then slide
the brackets as shown in the illustration. After
extending the anti-tip brackets, reinstall the
screws that secure them in place, but do not
tighten the screws fully at this time.
[Inside of side panels]
3-2.
If you plan to locate the piano and stand
against a wall, loosen the two screws (one on
the outside of each side panel) that secure
the brackets. You do not need to remove the
screws in this case.
• In this case, you do not need to remove the screws.
Just loosen them.
C
C C
A B
IMPORTANT!
Joint connectors
• When inserting a screw into a
joint connector, keep your
finger on the joint connector
hole on the back of back board
C
to make sure the joint
connector does not come out
of the hole.
PX760-ES-1A.indd 39 2014/06/24 10:35:16