Epson P-7000 - Manual (Page 25)

3. Set the date and time using the 4-way ring.
4. After you finish all settings, select Complete using the Right or Left key, then press the OK key.
Note:
❏ If approximately 24 hours passes after removing the battery, the date and time settings may be lost,
and will need to be set again.
❏ If the date and time settings are erased, the Date and Time screen is displayed when you turn on
the viewer next time.
❏ After changing the battery, make sure that the date and time is set correctly. If necessary, set the
date and time again.
❏ You can change the settings later. For details, see "Changing the Viewer Settings" on page 85.
Turning the power off
1. Make sure that the Access lamp is off.
2. Slide the power switch to as shown below and hold it down for several seconds until the shut
down display appears. The power switch will return to the original position.
R41A0K180 User’s Guide
Getting Started 25