Epson DW073 - Manual (Page 4)

2
English
• Store idle tools out of reach of children and other untrained
persons. Tools are dangerous in the hands of untrained users.
• When battery pack is not in use, keep it away from other metal
objects like: paper clips, coins, keys, nails, screws, or other
small metal objects that can make a connection from one ter-
minal to another. Shorting the battery terminals together may
cause sparks, burns, or a fire.
• Check for misalignment or binding of moving parts, breakage
of parts, and any other condition that may affect the tools
operation. If damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained tools.
• Use only accessories that are recommended by the manufac-
turer for your model. Accessories that may be suitable for one
tool, may create a risk of injury when used on another tool.
SERVICE
• Tool service must be performed only by qualified repair per-
sonnel. Service or maintenance performed by unqualified person-
nel may result in a risk of injury.
Additional Safety Rules
WARNING! DO NOT DISASSEMBLE LASER LEVEL. There are
no user serviceable parts inside. Disassembling the laser level will void
all warranties on the product. Do not modify the product in any way.
These devices comply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio and television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
These Class B digital devices comply with Canadian ICES-003.
CAUTION: Some tools with large battery packs will stand upright
on the battery pack but may be easily knocked over. When not in use,
place tool on its side on a stable surface where it will not cause a trip-
ping or falling hazard.
• The label on your tool may include the following symbols.
V ................volts A ................amperes
Hz ..............hertz W ..............watts
min ..............minutes ..............alternating current
............direct current no ..............no load speed
................Class II ................ earthing
....................Construction .................... terminal
................safety alert .../min..........revolutions or
.................... symbol .................... reciprocations
.................... .................... per minute
Important Safety Instructions for
Battery Packs
Your tool uses a 9.6, 12.0, 14.4 or an 18 Volt D E WALT battery pack.
When ordering replacement battery packs, be sure to include catalog
number and voltage. Extended Run-Time battery packs deliver more