Casio DT-X10 - Manual (Page 22)

E-20
11 IR Port
12 Power Contacts
13 CLR Key
14 Fn Key
15 PC Card Slot
16 USB Port
17 Headset Jack
18 Battery Pack
Cover Lock
Switches
19 R Trigger Key
20 L Trigger Key
21 Wrist Strap Hole
22 C-MOS Imager
(C-MOS Imager
models only)
Reader Port
(Laser Scanner
models only)
23 Reset Switch
24 CF Card Slot Unit
Terminal
25 Battery Pack
Cover
This port is used for IR data communication with another
Handheld Terminal or the Bridge Satellite Cradle.
Contact point for supplying power from the Bridge Satellite
Cradle and Cradle-type Battery Charger.
Press to clear all key inputs.
Press this key and then a function key or number key to
configure settings or to run previously registered applications.
For insertion of a separately available PC card.
For connection to a computer or other device using a USB cable.
For connection of a commercially available headset ( ∅2.5mm).
Slide these switches to lock and release the battery pack cover.
Press to perform a code read operation. This is also pressed to
perform a full reset.
Press to perform a code read operation.This ia also pressed to
cancel a full reset.
Connect the wrist strap here.
Reads barcodes and 2-dimensional codes.
Emits a laser that reads bar codes.
Press to reset the Handheld Terminal.
For connection of a separately available CF Card Extension
Unit.
Covers the compartment that holds the battery pack.
DT-X10_E_P14_36.p65 05.4.1, 11:04 AM 20