Casio AP-80R - Manual (Page 39)

E-37
Assembly Instructions
CAUTION
• Take particular care to avoid injury when installing legs and
pedals, and when mounting the keyboard onto the stand.
• When assembling, make sure that the sliding keyboard cover of
the digital piano body is completely closed. If the cover is left
open during assembly, it may close suddenly causing the fingers
to be pinched between the digital piano body and cover.
IMPORTANT!
• Be sure to assemble the stand on a flat surface.
• This stand does not include any of the tools required to assemble
it. You should have a large Phillips head (+) screwdriver on hand
for assembly.
• Check the items that come with the unit to make sure that
everything shown in Figure 1 (A through I) is included.
All screws are in a plastic bag inside of the packing cardboard.
• Before starting actual assembly of the stand, undo the clip at
location 1 (Figure 2) where the pedal cable comes out the back
of crosspiece D.
1 Assembling the stand
Refer to Figures 3, 4 and 5 as you assemble the stand according to
the following procedure.
1 Attach side uprights A and B to crosspiece D using
the four E screws (Figure 3).
• When joining the two pieces marked 2, the metal pieces
3 on the insides of side uprights A and B should fit into
the slots at the ends of crosspiece D. Make sure the metal
pieces are pushed into the slots as far as they will go. If
they are not, the metal pieces 3 and the screws E will not
match up correctly, which can cause stripping of the
screws.
D
C
×4
×6
×1
×2 E
F
G
H
I
×4
A
B
Figure 1
Figure 2
1
Figure 3
3
2
A E
E
I
I
I
D
C
E
B
Crosspiece
Side upright
429A-E-039A
AP80R_e_29-41.p65 04.8.26, 3:44 PM 37