Epson 11880 - Manual (Page 3)

Loading Roll Paper Loading Roll Paper
1
Slide the black paper stop off the end of
the spindle.
Note: To use paper with a 3-inch core, attach the
gray adapters to the paper stops at each end.
See your Printer Guide for details.
2
Position the roll as shown, then slide the spindle into
the roll.
3
Slide the black paper stop back onto the spindle and
insert it firmly into the end of the roll.
4
To adjust the tension, slide the switch to H for high
tension (for most fine art papers) or N for normal.
5
Open the roll paper cover.
6
Place the roll paper in the printer as shown. (The
black end of the spindle goes on the left.)
7
Align the roll with the rails on both sides, and roll it
onto the mounting brackets.
8
Make sure the printer is turned on, then press the
Paper Source button until the or icon
appears.
2
9
Release the paper lever. If the lever is locked, press
and hold the button for 3 seconds to unlock it.
10
Feed the paper into the slot and pull it all the way
through.
11
Turn the roll back to remove any slack. Then align
the bottom edge with the horizontal and vertical
lines.
12
Return the paper lever to the locked position. Then
close the roll paper cover.
13
Press the Pause button. The paper feeds into
printing position.
14
Check the printer’s control panel and select the
correct media type.