Reading the barometric pressure, Setting the channel, Displaying the outdoor temperature – Auriol Z31092 User Manual

Page 10

10 GB

from your device and from the local weather
forecasting service, please take the advice of the
latter as authoritative.

Press the HISTORY / WEATHER button

for about 3 seconds. The weather symbol

flashes.

Set the current weather by pressing
the “+“ / °C / °F button

or the

“–“ / MAX / MIN button

You can choose between the following
weather symbols:

= sunny

= light clouds

= cloudy

= cloudburst /

storm

= rainy

Press the HISTORY / WEATHER button

confirm your settings.

Note: Ensure that you have set the current
weather correctly, otherwise the weather
forecast will not be correctly displayed.

The weather station starts with the weather
forecast approximately 6 hours after you
enter the current weather.

The weather station can display the barometric
pressure trend

. You may see the following

displays:

= the barometric pressure will rise.

= the barometric pressure will remain

constant.

= the barometric pressure will fall.

Reading the barometric

pressure

Press the Relative / absolute barometric pres-
sure button

to switch between the relative

and absolute barometric pressure display.

Note: The display shows “Abs” if you have
selected absolute pressure. The display shows
“Rel” if you have selected relative pressure.

Note: The absolute barometric pressure is
measured by the weather station.

Set the relative barometric pressure to the
barometric pressure relative to that at sea
level. Ask your local weather forecast service
for the barometric pressure at sea level.

Press and hold down the Relative / absolute
barometric pressure button

for about

3 seconds.

Set the current barometric pressure by press-
ing the “+“ / °C / °F button

or the

“–“ / MAX / MIN button

Press the Relative / absolute barometric
pressure button

to confirm your settings.

Reading the barometric

pressure for the last 12 hours

Press the HISTORY / WEATHER button

to read the barometric pressure values for
the last 12 hours.

0HR = present barometric pressure

– 1HR = barometric pressure an hour earlier

– 2HR = barometric pressure two hours

earlier, etc.

Press and hold down the “+“ / °C / °F button

for about 3 seconds to switch between

displaying the barometric pressure units in
inHg or mb / hPa.

Setting the channel

To do this open the battery compartment on
the back of the outdoor sensor and take it off.

Set the channel by means of the Channel
selection switch

Press the channel button

for approx. 3

seconds until a signal is sounded. The wea-
ther station has now received one signal.

Press the TX button

to transmit the measured

temperature to the weather station manually.

Then close the battery compartment

Displaying the outdoor

temperature

Press the Channel button

to display the

outdoor temperature of each outdoor sensor.

– Press the Channel button

1 x to display

channel 1.

– Press the Channel button

2 x to display

channel 2.

– Press the Channel button

3 x to display

channel 3.

– Press the Channel button

4 x to display

all the channels one after the other in a loop.
Only the outdoor sensors which can be
addressed are displayed.

Press and hold down the Channel button

to remove unused channels. If a further out-
door sensor and channel are added later,
the weather station will receive the signal
automatically. Alternatively, you can also
transmit the initial signal from the outdoor
sensor manually by pressing the TX button