Inserting and replacing batteries – Auriol H13726 User Manual
Page 9
9
GB
Inserting and replacing batteries
9. Inserting and replacing batteries
Put the batteries first into the outdoor
sensor (wind gauge / rain gauge), then
into the weather station.
Weather station:
– Open the battery compartment on the rear of
the weather station in the direction of the arrow.
– Insert the batteries (6 x 1.5 V type AA) ensuring
correct polarity. When one of the two battery
rows is full, a beep sounds.
– Place the battery compartment cover on the
battery compartment to close. Push the battery
compartment cover in the opposite direction to
the arrows until it engages.
Wind gauge:
– To open the battery compartment, loosen the
4 cross-head screws on the battery compartment
cover.
– Lift off the battery compartment cover.
– Insert the batteries (2 x 1.5 V type AA) ensuring
correct polarity. Ensure that the black strap lies
under the batteries. This strap can be used to
remove the batteries when they need to be re-
placed.
– Place the battery compartment lid on the bat-
tery compartment again. Ensure that the sealing
ring on the battery compartment is positioned
correctly in the recess. Only then is the battery
compartment waterproof.
– Tighten the 4 screws on the battery compart-
ment cover again.
Rain gauge:
– Use a slotted screwdriver to loosen the 2 adja-
cent fastening screws on the housing of the rain
gauge.
– Lift the housing carefully off the base of the device.
– To open the battery compartment, loosen the
4 cross-head screws on the battery compart-
ment cover.
– Lift off the battery compartment cover.
– Insert the batteries (2 x 1.5 V type AA) ensuring
correct polarity.
– Place the battery compartment lid on the battery
compartment again. Ensure that the sealing ring
on the battery compartment is positioned cor-
rectly in the recess. Only then is the battery
compartment waterproof.
– Tighten the 4 screws on the battery compart-
ment cover again.
– Place the housing carefully over the base of the
device.
– Fix the housing onto the base of the device
again with fastening screws.