Curtis IP1006UK - Manual (Page 9)

9
Setting the Clock
1. Power off the unit.
2. Press and hold the CLK SET button.
3. While holding the CLK SET button, press the REV / HR button to cycle up
through the hours. Press the FWD / MIN button to cycle up through he minutes.
4. Release the CLK SET button to set the specified time.
How to using radio
Antennas AM - If reception is weak, turn the unit to improve reception. FM - If
reception is weak, adjust FM Antenna length and the angle to improve reception.
1. Press the POWER button to power on the unit and the DISPLAY will be light.
2. Slide the AM / FM / CD / IPOD-AUX switch to select AM or FM Bands.
3. Adjust the VOLUME control on the control panel of the unit as desired.
4. Tune a station by turning the TUNING control on the right side of the unit.
5. Turn off the unit, press the POWER button to off power.
AUX IN-Connecting Other Digital Audio Devices
1. Use a line-in cord to connect an iPod shuffle or other audio device to the AUX-IN/
LINE IN port.
2. Slide AM / FM / CD / IPOD-AUX switch to IPOD-AUX position. Turn on the
external audio device and use the deviceʼs control playback.
Notes: If use AUX mode, make sure the docking compartment not connect any iPod.
AUX OUT-Connecting Other External Amplifier
1. To connect an external amplifier, connect a 3.5mm mini jack connection cable
(not included) to the AUX OUT jack on the rear of unit to the AUX IN/LINE IN
jack on the external amplifier.
2. Plays the Radio or Music as above procedure.
BBS (Bass Boost System) Function
Press the BBS button (remote control) to “Bass Boost” playing and press again the
button to cancel the BBS playing.
Bass boost
You can switch the bass boost function on and off using the BBS button.
OPERATING INSTRUCTIONS