Curtis IP1005BUK User Manual

Page 9

c. Press PLAY/BAND Button to select your desired band.
d. Press SKIP-/TUNE- or SKIP+/TUNE+ Button to your desired radio station.
e. Press VOL- or VOL+ Button to adjust the volume as desired.
f. Press POWER button to turn off the unit.
g. Press FUNCTION/AL. SEL button to select the “TUNER” source.

Note

: To deactivate the alarm (Radio sound) manually, press the POWER/AL. OFF BUTTON to turn

off.

WAKE UP TO iPod:
a. Press the POWER/AL. OFF BUTTON to switch power on.
b. Press the FUNCTION BUTTON to the iPod function.
c. Insert the iPod into the iPod docking.
d. Press VOL- or VOL+ Button to adjust the volume as desired.
e. Press the POWER/AL. OFF BUTTON to switch power off.
f. Press FUNCTION/AL. SEL button to select the “iPod” source.
g. The iPod will sound at the set alarm time.

To deactivate the alarm (iPod playing) manually, press POWER/AL.OFF Button.

SNOOZE FUNCTION
When you are awakened but wish to sleep a few minutes more, simply press the
“SLEEP/SNOOZE” button and it will shut off the alarm sound for approximately 9 minutes before
the alarm sounds again. “SNOOZE” signal will show on the LCD Display. This can be repeated
several times.

RADIO OPERATION
1. Press Power/AL. Off button to turn on the unit.

2. Press the FUNCTION/AL. SEL Button to “RADIO” mode.

3. Press the PLAY/BAND Button to the desired band (AM or FM).
4. How to tune the radio

i. Manual

Tuning

Press the SKIP+/TUNE+ or SKIP-/TUNE- to search for desired frequency. Higher
frequency can be selected by pressing the “SKIP+/TUNE+” button while Lower
frequency can be selected by pressing the “SKIP-/TUNE-” button

ii. Automatic

Tuning

i) Press and hold the SKIP+/TUNE+ BUTTON or SKIP-/TUNE- BUTTON until the
display frequency starts run.
ii) When a station of sufficient strength has been found Tuning will stop or you can stop
the automatic tuning by pressing SKIP+/TUNE+ or SKIP-/TUNE-BUTTON.

5. Press VOL-/VOL+ Button to your preferred Listening Level.

6. After listening, Press the POWER/AL. OFF BUTTON to turn off the unit.

Note: If the reception is strong enough. “ST” will display in the LCD Display indicate it is in FM STEREO mode. If

stereo signal is too weak, press MONO/SHUFFLE BUTTON to mono mode, “MONO” will display in the

LCD Display, the reception will be improved.