Curtis RCD3830 - Manual (Page 7)

6
B AT T E RY I N S TA L L AT I O N
1.) Open the battery compartment cover.
2.) Insert two "AAA" (UM4) batteries (not included)
to match the polarities as indicated inside the
battery compartment.
3.) Close the cover.
NOTE: When the batteries become too weak, the operating distance of the
remote controller is greatly reduced and you will need to replace the batteries.
USING THE REMOTE CONTROLLER CORRECTLY
•Point the remote controller at the Remote Sensor.
•The functions of the buttons on the remote control are the same as the
corresponding controls on the main unit.
•When there is a strong ambient light source, the performance of the infrared
Remote Sensor may be degraded, causing unreliable operation.
•The maximum effective distance for remote control operation is about 15 feet.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old batteries
with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage
or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’ s directions.)