Curtis DVD8723UK - Manual (Page 6)

P - 5
Power Sources
Battery installation (remote control unit)
1. Remove the battery cover.
2. Insert one battery (CR 2025) making sure the polarity (+ / –) matches the
marks inside the unit.
3. Replace the cover.
Do not attempt to recharge, short-circuit, disassemble, heat or throw the
batteries into the fire.
Charging the Battery
Unit has build-in NiMH battery, then refer the step of “Using AC Adapter for
player” to connect power converter.
Notes:
• For the kind of Ni-MH rechargeable battery, it will not be fully charged when
a battery to be charged first time, please note that the discharging time will
be short.
• The battery will be operated normally with normal capacity after 4~5 times
of charging and discharging. It is not a defect and abnormal battery.
• After a period of storage, or not use for a period, it will require users to repeat
above mentioned steps to get the battery back to normal condition.
• The battery is fully charged for approximately 4~5 hours after the AC
adaptor is connected.
Battery is charging the CHARGE indicator at the front will light on RED. When
charging is completed, the FULL indicator will light on GREEN.
Notes:
• Disconnect the AC adapter plugs from both the battery and the AC outlet,
when charging is completed or not necessary.
• Battery recharge circuit operates in OFF mode and STANDBY mode. But
Switch off the unit for battery recharge is recommended.
• When battery is fully charged and released from unit, the CHARGE indicator
will light on RED, it means the charge circuit is ON.
Battery Low Indication
When using the rechargeable battery to playing and the battery is nearly
exhausted, the player front “STANDBY” indicator will blinking. In a while, the
power will be turned off automatically. Refer “Charging the Battery” to re-
charge the battery.
Using AC Adapter for Player
Insert the DC plug at the end of the adapter cord into the DC IN jack at the right
side of the player. Then plug the other end into an AC wall outlet.
Notes:
• Only use with the supplied AC adapter. Using with other AC adapter could
be damaged.
• Remove both DC plug & AC-IN plug, to disconnect the AC adapter when
not necessary.
Using the Car Adapter (For cars with Negative
grounding only)
Plug the small end of the car adapter into the DC IN jack and then plug the
other end into the cigarette lighter socket. This indicator lights when the power
is on.
T580_Curtis_A5_size_UK_Eng_ib.p65 12/20/2006, 10:47 AM 5
Black