Curtis DVD1040 - Manual (Page 15)

- 15 -
TROUBLESHOOTING
SYMPTOM CHECK ITEM
The player does not play.
-If the disc is not loaded in.
-If the disc is loaded upside down.
-If the disc is dirty or warped.
-If the local setup is not the same as the area code of
DVD discs.
-If water condensation have occurred.
If it occurs, take out the disc and leave the player on for
1-2 hours.
There is no sound.
-If the system connection is incorrect.
-If the speaker power is not turned on.
-If the audio setup of DVD or SVCD discs is incorrect.
-If the disc is dirty or warped.
If it occurs, clean it or press it with books about 4-5kg.
There is no picture.
-If TV is not turned on or not in video mode.
-If the system connection is incorrect.
Picture move up and down. Unsteady.
-If the signal system is incorrect.
If it is true, select correct system.
Cannot continue to play and play a
section repeatedly.
-If it is in A-B repeat status.
If it is true, press A-B button to cancel it.
-If the disc is dirty or damaged.
If it is true, clean it or select by time to skip the section.
The remote control does not work.
-If there are obstructions between the remote control
and the player.
-If you do not point the remote control at remote sensor.
-If batteries are not inserted.
-If batteries are weak.
If it is true, replace the batteries.
Others:
If you are still having problems and tried the above methods of rectification, then please
disconnect the power and consult your service center or a qualified technician.