Curtis DVD5091UK - Manual (Page 28)

-26- Troubleshooting
Problems and Solutions
Solution
Plug the power cord into the power supply
Set correct TV video input format for receiving
the player`s output signals.
Firmly insert the video cable ends to the
related terminals.
Firmly insert the audio cable ends to the
related terminals.
Turn on the power of audio apparatus.
Setup audio output correctly via the setup
menu.
Take out the disc and clean.
The picture may be distorted during
fast-forward/backward playback.
Connect the player directly to TV.
Load a disc.
Load a compatible disc(Check the disc format
and its color system.)
Replace the disc with label side face up
Put the disc in correctly
Clean the disc.
Change the setting via the setup menu.
Disable this function or reset the rating level.
Turn off the main switch or pull out the power
plug. plug in and turn on the power again.
Point the remote control at the remote sensor.
Make sure the remote control range within 7
meters to the remote sensor.
Replace with new batteries.
Cause
Power plug not connected
TV has not been set to the correct
video input
Video cable not firmly connected.
Audio cable not connected tightly
Power of audio apparatus is off
Audio output setting is incorrect
Disc is dirty
Fast forward/backward is activated
Affected by anti-piracy circuit
No disc
Disc not compatible
The disc is placed upside down
The disc not put in the tray correctly
Disc is dirty
Parental lock is in effect
Player setting are incorrect
Interference of power wave or other
factors such as static interference
The remote control not pointed at the
remote sensor on the front panel of
the player
The remote control is out of specified
range
Battery power exhausted
Problems
No power
indication
No picture
No sound
Picture distortion
Brightness
unstable or noisy
The player does
not work
No response to
button press
Remote control
does not work