Parkside PTSS 1200 A1 - Manual (Page 11)

11 GB
Safety notices specific to circular saws Start-up / Operation
Start-up
Installing / replacing
the saw blade
Pull the mains plug out of the mains socket before
you carry out any task on the device.
1. Activate the switch lock 1 and push the motor
unit 6 forward.
2. Release the locking lever 18 . Release the switch
lock 1 . The motor unit will lock into place.
3. The clamping screw / washer 14 a is now located
in the cut-out 14 b .
4. Push the spindle lock 19 and use the socket
head wrench 5 to undo the clamping screw /
washer 14 a .
5. Remove the saw blade 14 .
6. Install the saw blade 14 in the respective reverse
order.
The direction of rotation of the saw blade and
device must match.
Connecting the saw
dust extraction
Optionally attach the chip discharge adapter for
the dust extraction
7 to the chip discharge 17 .
Connect an approved dust- and chip extraction
system.
Checking the guard function
Note: for this process, place the baseplate at the
edge of a firm surface so the saw blade
14 can be
lowered.
Lower the plunge saw.
Check if the saw blade
14 rubs against the
guard and if it independently returns to the
starting position.
Operation
Switching on and off
Switching on:
Slide the switch lock 1 up and keep in position.
Activate the ON / OFF switch 2 . Once the ma-
chine has started, release the start lockout 1 .
Switching off:
Release the ON / OFF switch 2 .
Adjusting the cutting depth
(plunge depth)
Loosen the screw on the depth adjustment 12
and slide the stopper to the desired cutting
depth shown on the depth scale
13 :
- without guide track see marking A.
- with guide track see marking B.
Tighten the screw for the depth adjustment 12 .
Note: adjust the cutting depth to the thickness
of the work piece. No more than one tooth
depth should protrude below the work piece.
Adjusting the cutting angle
(mitre square)
Loosen both adjustment wheels for the cutting
angle
11 .
Slide the motor to the desired cutting angle.
Tighten the adjustment wheels 11 .
Note: if the cutting angle adjustment for 0 ° or 45 °
moved, they can be readjusted with the micro-adjust-
ment screws
8 and 8 a .
Note the cutting line
The saw stand 9 is embossed with 0 ° / 45 °
cutting line markings 9 a .
Align the tool with the respective cutting angles
using the 0 ° resp. 45 ° cutting line marks
9 a .
The slants are reference points.