Parkside POF 1200 A1 - Manual (Page 12)

12 GB
… / Disposal / Translation of the original declaration of conformity / Manufacturer Operation / Maintenance and Cleaning / Warranty
Milling with the copy casing
Note! The pattern must be at least as high as the
copy casing’s
26 thrust ring 25 .
Note! Chose the router bit as small as the inner
diameter of the copy casing.
When using a copy casing 26 the pattern can be
transferred onto the work piece.
Place the router with the copy casing on the
pattern.
Loosen the clamping lever 16 by turning it clock-
wise and lower the device until it reaches pre-
determined depth.
Lead the device with the protecting copy casing
along the pattern. Apply pressure lightly.
Milling with a rip fence
Push the rip fence 24 along the guide rail 6 of
the base plate 7 and tighten the screws 5 .
Put the rip fence 24 on the edge of the work
piece (see fig. F, H).
Milling with a circular
compass (see fig. J)
Put the centring pin 30 in the marked mid point
of the circle.
Turn the rip fence 24 over, i.e.the fence side is
facing upwards.
Screw together the centre pin and the rip fence
with a wing bolt. Lock the centre pin to the screws
with the slot of the open-ended spanner
27 .
Maintenance and Cleaning
RISK OF INJURY! Switch the
device off and pull the plug out of the mains socket
before carrying out any work on the device.
Always keep the device clean, dry and free of
oil or grease.
Use a dry cloth to clean the housing.
If the connection cable needs
to be replaced, this repair must be performed
by the manufacturer or a representative to pre-
vent safety hazards.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
Warranty
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
The warranty is void in the case of abusive and im-
proper handling, use of force and internal tampering
not carried out by our authorized service branch. Your
statutory rights are not restricted in any way by this
warranty.
The warranty period will not be extended by repairs
made unter warranty. This applies also to replaced
and repaired parts. Any damage and defects extant
on purchase must be reported immediately after
unpacking the appliance, at the latest, two days after
the purchase date. Repairs made after the expiration
of the warranty period are subject to payment.