Parkside PNTS 1400 B1 - Manual (Page 8)

8
GB
with the locking lever adjusting screw).
Several positions are possible for the
bow handle.
. Never.vacuum.without.a.filter!
6. Fit the power cable holder (4) onto the
motor head (3) and screw it in place
with 2 crosshead screws.
7. Fit the accessories:
- Connect the suction hose (21).
- Fit the handle (22)
- Fit the telescopic suction pipe (19).
(Press the knob on the telescopic
suction pipe in the direction and
separate to the desired length).
- Fit the desired nozzle (27/28).
To store the suction set during breaks,
push together the telescopic suc-
tion hose and plug the suction pipe
holder into the socket on the motor
housing (see picture below).
Operation
Switching on/off
Connect the mains plug.
Do not vacuum without a filter!
(How to insert the filter is described
in the chapters “dry vacuuming“
and “wet vacuuming“).
Switching.On:
On/Off Switch (see 6) In position “I“
Switching.Off:
On/Off Switch (see 6) In position “0”
Dry vacuuming
1. For dry vacuuming, fit the pleated filter
(25) onto the filter basket on the motor
head (3). The sealing lip that curves
upward must point away from the mo-
tor head.
2. Fit the filter cover (24) and lock it with
a light turn:
Lock the filter cover
Unlock the filter cover
Vacuuming.fine.dust:
While vacuuming fine dust, you
may find dirt accumulating faster
than usual. For this reason, we
recommend the use of a paper filter
bag for fine dust.
1. Fit the pleated filter (25).
2. Fold the side flaps on the paper filter
bag (26) down on the perforation.
3. Completely unfold the paper filter bag
(26) and pull it over the internal suc-
tion nozzle (8) in the stainless steel
container (9). The connector on the
suction nozzle must be completely en-
closed by the sealing ring on the filter
bag opening.
Wet vacuuming
For wet vacuuming or to vacuum water, fit
the foam filter (23) to the filter basket on
the motor head (3).
When the container is full, the suc-
tion opening is shut off by a float,
and suction is then cut off.
Switch the appliance off, remove
the plug from the socket and empty
the container (see “Cleaning/Main-
tenance/Storage”).
If foam or liquid exits, switch off the
machine immediately.