Parkside PHD 100 A1 - Manual (Page 40)

40
GB MT
• To cancel the wheel fixing, push the
two bolts (16) upwards.
F Removing the Chassis
The pressure washer can also be used
without the chassis (9).
• Press the release button (18) on the
front locking point. Hold the chassis
(9) securely in the front area and pull
the pressure washer upwards.
At the same time, tilt the pressure
washer slightly to the rear.
• To reinstate, insert the device into
the rear area of the chassis (9). Push
down on the device down and press
the release button (18) at the same
time. The device clicks into the chas-
sis.
Cleaning and Mainte-
nance
Pull out the power plug before eve-
ry maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
Cleaning
Never direct the water jet
against the washer, nor clean
the washer under flowing water.
This could give rise to the dan-
ger of electric shock and dam-
age the washer!
Always keep the washer clean. Do not
use any detergents or solvents.
• Always keep the ventilation slots
clean and free.
• Only clean the pressure washer with a
soft brush or a slightly moist cloth.
• In case a nozzle of the jet tube (12/13)
is clogged up, use the nozzle cleaning
pin (15) to remove the object from the
nozzle.
G If necessary, take off the water
connection with the filter insert (8)
and clean the filter insert.
Maintenance
The pressure washer is maintenance free.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only origi-
nal parts.
Storage
• Drain all the water from the pressure
washer. Disconnect the unit from the
water supply. Press the On/Off switch
( A 5) to turn on the pressure washer
for no longer than 1 minute until no
more water escapes from the high-
pressure connection ( A 5). Turn off
the unit.
• Protect the pressure washer and its
accessories from frost when they
have not been completely drained of
all water.
• Store the pressure washer and its ac-
cessories in a frost-free room.
• To transport or put away the equip-
ment, use only the carrying handle.
• Store the equipment only in a horizon-
tal position in order to protect it from
any damage.