Parkside Pressure Washer Attachment - Manual

1 High pressure connection
on the gun side
2 Cap nut
3 Top extension pipe
4 Bottom extension pipe
5 Brush
6 Pull-out lip
7 Adapter
Also observe the safety instruction
for your pressure washer.
Pressure washers can be dan-
gerous if used incorrectly. Do
not direct the jet at people, ani-
mals, live electrical equipment or the
equipment itself.
Technical specifications
Max. pressure ................160 bar / 16 MPa
Intake temperature ......max. 60°C / 140°F
Initial Operation
Screw the brush (5) onto the bottom ex-
tension pipe (4). Screw the bottom exten-
sion pipe (4) onto the top extension pipe
(3).
Plug in and twist to connect the pressure
scrubber to the spray gun of your PHD
150 A1 pressure washer via the high
pressure connection on the gun side (1).
Screw the cap nut (2) against the spray
gun for a firm grip.
The enclosed adapter (7) may be helpful
for use with another device. Plug in and
twist to connect the adapter (7) to the high
pressure connection on the gun side (1).
Screw the cap nut (2) against the adapter
(7) for a firm grip. After connecting the
pressure scrubber to the spray gun, the
1
2
3
4
5
7
GB
6