Parkside PHD 100 A1 - Manual (Page 8)

8
GB IE
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent haz-
ards.
• Do not pull the plug from the socket
by the cable. Protect the cable from
heat, oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are
protected from spray water and de-
signed for outdoor use. Always fully
unroll a cable drum before use. Check
the cable for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of the power supply
cable must not be less than 2 x 1,5
mm².
Areas of Application
Only use the pressure washer in the fol-
lowing private home areas:
• To clean machines, vehicles, build-
ings, work tools, facades, terraces,
gardening tools, etc. with a high-pres-
sure water jet.
• Only use with original accessories and
spares.
• Observe the manufacturer’s instruc-
tions for the device that is to be
cleaned.
General Description
The diagram of the most im-
portant functional elements
can be found on the foldout
side.
Overview
A
1 High-pressure connection on
the gun side
2 High-pressure connection on
the washer side
3 High-pressure connection
4 Carrying handle
5 ON / OFF switch
6 Accessories holder
7 Power supply cable
8 Water connection with sieve in-
sert (not visible)
9 Chassis
10 Gun
11 Jet lance
12 Adjustable flat-jet nozzle
13 High-pressure nozzle
14 Cleaning agent container with
nozzle
15 Nozzle cleaning pin
Functional description
The pressure washer is to be used for
washing with a high-pressure water jet. A
detergent can be added if this is required.
For the functions of the operating ele-
ments please refer to the subsequent
description. Ensure that the safety instruc-
tions are always observed!