Echo Trimmer - Manual (Page 13)

P
OWER
P
RUNER
TM A
TTACHMENT
O
PERATOR
'
S
M
ANUAL
13
1. Wipe debris from around oil fill cap.
2. Remove oil fill cap and fill reservoir with a quality, low viscosity
guide bar and saw chain oil.
NOTE
The discharge volume of the automatic oiler is preset to deliver 3
to 4 cc/min. at normal operating RPM. During heavy or dry
cutting conditions the oil discharge volume may be adjusted to
assure adequate lubrication. Refill the oil reservoir with each tank
of fuel.
IMPORTANT
To prevent plastic deterioration, do not use synthetic or silicone
based oil.
ADJUSTING AUTOMATIC OILER
Tools required: 10 mm (13/32 in.) Wrench, Screwdriver
1. Remove two (2) 10 mm guide bar retaining nuts and sprocket
cover.
2. From bottom of gear case, turn adjustment screw (A) clockwise to
decrease oil volume - counter clockwise to increase oil volume.
NOTE
Very little visible oil on the saw chain will provide sufficient
lubrication.
P
RE
-O
PERATION
LUBRICATING THE GUIDE BAR AND SAW CHAIN
Automatic Oiling System
A