Parkside PAS 500 B1 - Manual (Page 34)

34
GB MT
4. Plug the suction tube (12) onto
the rigid end piece of the suc-
tion hose (11).
Switching on/off
Connect the mains plug.
The equipment is fitted with a
safety stop, which allows operation
only with the pleated filter and wire
filter basket installed correctly.
Switching On:
On/Off Switch (see 6) In position “ I“
Switching Off:
On/Off Switch (see 6) In position “ 0”
Operating Instructions
The vacuuming of glowing em-
bers and of materials that are
combustible, explosive or harm-
ful to health is prohibited.
There is a risk of injury!
• Place the equipment on a level sur-
face that is not heat sensitive.
• Always use the suction tube for vacu-
uming. Hold the suction tube at a dis-
tance of approx. 1 cm above the ash.
• Vacuum only cooled ash at less than
40°C.
• When vacuuming, keep checking the
metal container and suction hose for
rises in temperature.
• In the event of a rise in temperature,
switch off the equipment and discon-
nect at the plug. Place the equipment
outside and monitor it as it cools.
• During breaks, you can place the suc-
tion hose ( 12) in the accessory
holder ( 2) on the container lid.
• Always use the carry handle ( 9) for
transporting the equipment.
• The metal container may be filled to
no more than half, so the pleated filter
always remains clear.
• Empty the container outside in order
to avoid mess (see “cleaning/mainte-
nance“).
• Clean the pleated filter ( 13) (see
“cleaning/maintenance“) if the suction
performance deterio rates or when the
inspection window blockage indicator
( 3) on the container lid turns red.
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
Never hose the appliance down
with water. Never use aggres-
sive cleaning agents or sol-
vents. This could damage the
appliance.
General Cleaning Work
Clean the equipment after each use:
• Carry out cleaning outside in order to
avoid mess.
• Take off the container lid ( 5) and
empty the metal container ( 10).
Clean the metal container with water
and allow it to dry.
• Clean the wire filter basket and the
pleated filter (see below).
Cleaning the Wire Filter Bas-
ket and Pleated Filter
Replace the pleated filter if it is
worn, damaged or heavily soiled
(see “replacement parts“).