Emprex LCD Monitor LM-1702 - Manual (Page 6)

6
Setup
1. Connecting video
(Note: Before connecting computer, ensure the resolution and refresh rat e of the computer do not exceed the
following setting s - resolution: 1280*1024, refresh rate: 75Hz.)
1.1 Turn off your computer
1.2 Connect the video signal cable to the VGA port of your PC, tighten the screws on the connector onto the
computer
1.3 Connect the other end of the video signal cable to the VGA-IN port at the back of the monitor, tighten the
screws on the connector to the monitor
2. Connecting power
2.1 Plug
the female end of the power cord in to the AC-IN port at the back of the monitor
2.2 Plug the male end of the power cord into a power outlet
3 Connecting audio (optional)
3.1 Plug the audio cable into the AUDIO port at the back of the monitor
3.2 Plug the other end of the audio cable into your computer or other audio source
4. Turning on the computer
5. Pressing the button at the back of the monitor to turn on the monitor
6. Removing the protection film from the monitor
You should be able to see the picture now. I f not, refer to the “Troubleshooting” section.