Emprex LCD Monitor LM-1702 - Manual (Page 12)

12
Interface Frequency
1. The following frequency range is the working period. If the entered mode is between the below period but does
not match the frequency of supported timing, display optimization will not be assured. If the entered mode is out of
the working period, the display will be blank (just show “Input Signal Out Of Range”) then go to power saving.
2. Basically , mode judgment is regardless the sync polarity except if both or more modes all belong to the supported
timing list and can be judged by sync polarity only.
3. In the meantime, the real entered frequency of the supported timing is not requested exactly.
4. Normalization of the VGA card’s deviation will be acceptable.
5. Horizontal Frequency 30 KHz---80 KHz
6. Vertical Frequency 50 Hz---75 Hz