Emerson CF680ORB00 - Manual (Page 8)

18. Slide the upper housing over the
downrod until it rests on the center
glass (Figure 8). Make sure the upper
housing is seated firmly on the rim of
the center glass, then tighten the
three setscrews in the upper housing
collar (Figure 9).
19. Make sure the grommet is properly
installed in the upper housing cover,
then slide the cover over the downrod
until it rests on the upper housing
(Figure 9).
8
SETSCREWS (3)
UPPER
HOUSING
COVER
GROMMET
COLLAR
UPPER
HOUSING
Figure 9
FAN MOTOR
AND HOUSING
ASSEMBLY
UPPER
HOUSING
CENTER
GLASS
Figure 8
20. Place the ceiling cover over the
downrod. Then reinstall the hanger
ball (Figure 10) on the downrod as
follows. Route the three 80” motor
leads through the hanger ball and
slide the hanger ball over the
downrod. Position the pin through the
two holes in the downrod and align
the hanger ball so the pin is captured
in the groove in the top of the hanger
ball. Pull the hanger ball up tight
against the pin and securely tighten
the setscrew in the hanger ball. A
loose setscrew could create fan
wobble.
DOWNROD
CEILING COVER
PIN
HANGERBALL
SETSCREW
Figure 10
21. The fan comes with blue, black and
white leads that are 80” long. Before
installing the fan, measure up
approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut
off excess leads and strip back
insulation 1/2” from end of leads.
22. You have now completed the initial
assembly of your new ceiling fan. You
can now proceed with hanging and
wiring your fan.
! WARNING
It is critical that the pin in the hanger ball
is properly installed and the setscrew
securely tightened. Failure to verify that
the pin and setscrew are properly
installed could result in the fan falling.
BP7305 Westfield 6/30/06 12:10 AM Page 8