Emerson CF680ORB00 - Manual (Page 5)

5
IMPORTANT: The side of the fan blade
having the rib line MUST be facing
upward as shown in Figure 1.
1. Mount the fan blades to the blade
flanges using three 10-32 x .30” pan
head screws and three flat washers
(screws and washers supplied)
(Figure 1).
How to Assemble Your
Ceiling Fan
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
! WARNING
To reduce the risk of personal injury, do
not bend the blade flange when installing
the blade flanges, balancing the blades or
cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
! WARNING
10-32 x .30"
PAN HEAD
SCREWS (3)
FLAT
WASHERS (3)
RIB LINE (THIS SIDE
OF BLADE UP)
FAN BLADE
BLADE
FLANGE
Figure 1
2. Remove and discard the four shipping
retainers securing the motor hub in the
motor housing.
NOTE: Take care not to scratch the fan
housing when installing the blade
assemblies.
3. Insert an 1/4-20 x 1/2” oval head screw
(supplied) into each of the two
recessed holes in one of the blade
flanges.
4. Position the blade flange on the motor
hub so that the screws in the blades
flange align with two threaded holes in
the motor hub (Figure 2). Loosely
tighten the screws at this time. Repeat
this procedure for the remaining four
blade assemblies.
5. Gently snug all flange screws to the
motor hub, working around the hub in a
clockwise sequence. Next, securely
tighten all flange screws, again working
in a clockwise sequence. Failure to
follow this procedure could result in fan
wobble. This completes the blade
installation.
1/4-20 x 1/2" OVAL
HEAD SCREWS (2)
BLADE
FLANGE
MOTOR FLANGE
REMOVE ONE PAN HEAD
SCREW/LOCKWASHER
MOTOR HUB
Figure 2
! WARNING
To reduce the risk of personal injury, do
not bend the blade flanges when
installing the flanges, balancing the
blades or cleaning the fan. Do not insert
foreign objects between rotating fan
blades.
BP7305 Westfield 6/30/06 12:10 AM Page 5