Linkskey LKS-SG9P4 - Manual (Page 10)

9-port Gigabit Ethernet Switch with 4-port PoE
8
Note:
Select the installation surface carefully. If the surface is not proper, the
reliability of this installation will be compromised
Too high installation position or vibration might cause a fall leading to
switch damage or personal injury
When installation is finished, don't move the switch very often to avoid
surface coating damage
To make it cable more easily, please place the switch bottom up when you
mount it vertically and pay attention to the weight of the installed cables to
avoid a fall
Keep magnets away from objects such as the floppy disk, magnetic card,
computer or computer monitor, which are easy to be magnetized
Wall Mount Installation
Step 1: Drill 2 holes with a diameter of 5mm on the wall. The distance between the
2 holes is 110mm, and the line through them should keep horizontal, as illustrated
in Figure 2-3.
Step 2: Install a drywall anchor inside the board hole; and flush the edge of the
drywall anchor with the wall surface.
Step 3: Fasten the screws into the drywall anchor. Distance between the inside
surface of the screw header and the edge of the drywall anchor should not be less
than 2.5mm, to make sure that the device can be hung on the bolt tightly.
Step 4: Align two wall type holes at the bottom of the device with the screw, and
hang the device on it.