Bang & Olufsen BeoVision 7-40/55 Getting Started - Manual (Page 31)

In
st
al
la
tio
n
an
d
se
tt
in
g
up
Calibrate the stand
Set the maximum angle the TV will turn – left and
right. The motorised movement of the TV will not
work until the calibration process has been
completed.
At SET LEFTMOST
POSITION turn left to the
point you wish to restrict
the movement to
At SET RIGHTMOST
POSITION turn right to the
point you wish to restrict the
movement to
Set preferred preset position for the TV to turn to, when it is switched on and
off. You need to calibrate the stand before you can use the motorised
movement of the stand.
At SET TOP POSITION tilt
up to the point you wish
to restrict the movement
to* 3
At SET BOTTOM POSITION tilt
down to the point you wish to
restrict the movement to* 3
Accept* 1
2 *Navigation button
3 *Tilt
If you have a Beo4 without navigation button or if your Beo4 is not set to the
correct mode, you cannot enable the navigation button. See the Beo4 guide
or contact your Bang & Olufsen retailer for further information.
If you have a Beo4 without navigation button, or if the navigation button on
your remote control is disabled, use the green button to tilt the television up
and the red button to tilt it down. NOTE! For further information about remote
controls and first-time setup, see the Guide.
This Getting Started and the Guide describe operation with the REMOTE
CONTROL menu set to NAVIGATION BUTTON and the remote control
set to MODE 1. Do not change MODE during first-time setup, as this will
interrupt the sequence.
Make standby settings for the TV
Make standby settings
Set the TV to switch itself to standby after some
time with no operation. You can also switch
Power Saving on or off. See the Guide for further
information.
STAND POSITIONS
STAND ADJUSTMENT
STANDBY SETTINGS
31