Bang & Olufsen BeoVision 7-40/55 Getting Started - Manual (Page 19)

D
ai
ly
u
se
Projectors
Dual screen
Subtitles
Not all connected projectors support 3D technology. If a projector connected to the television does not
support 3D, 3D in the 3D DISPLAY menu is greyed out in CINEMA mode.
If two sources are brought up on the screen at the same time or if teletext is brought up on one side
and a source on the other, the television will always display a 2D mode.
Subtitles may not always be supported.
Converts side-by-side 3D
signal into full screen 3D
representation by scaling
two pictures horizontally Converts top/bottom 3D
signal into full screen 3D
representation by scaling
two pictures vertically
SIDE-BY-SIDE 3D TOP/BOTTOM 3D
Converts side-by-side 3D
signal into full screen 2D
representation by scaling
one picture horizontally Converts top/bottom 3D
signal into full screen 2D
representation by scaling
one picture vertically Shows an ordinary 2D
TV picture without any
conversion.
STANDARD 2D SIDE-BY-SIDE 2D TOP/BOTTOM 2D
3D modes
Select the 3D mode that matches the signal sent
out by the progamme provider.
2D modes
Select the 2D mode that matches the signal sent
out by the progamme provider.
Automatic change of mode
If automatic 3D signalling is no longer available,
the television automatically switches to the last
used mode for the current source. At channel and
source change, the television switches to
STANDARD 2D, unless VIRTUAL 3D mode was
active. In this case it remains in this mode.
19