Bang & Olufsen BeoVision 4-85/103 - Manual (Page 7)

We expect your retailer to deliver, install and set up your product. However, regular
maintenance, such as cleaning, is the responsibility of the user. To achieve the best
result, follow the instructions below.
Maintenance
Cleaning instructions
Cautions
7
Cabinet surfaces
Wipe dust off the surfaces using a dry, soft cloth.
Remove grease stains or persistent dirt with a
soft, lint-free, firmly wrung cloth, dipped in a
solution of water containing only a few drops of
mild detergent, such as washing-up liquid. Never
use alcohol or other solvents to clean any parts of
the TV.
Plasma screen
Use a soft, dry cloth to wipe dust off the screen.
Do not use liquid cleaners or aerosol cleaners.
The screen is developed for indoor use in dry,
domestic environments only, and for use within a
temperature range of 10–40°C (50–105°F).
The picture can be distorted at altitudes where
the air pressure is lower than 833 hPa
(approximately 1500 m (5000 feet) or higher.
Do not place any items on top of the screen.
Due to the heavy weight of the screen, do not try
to lift it yourself. Leave such operations to
qualified personnel.
The screen is not designed to stand on its own. It
must be supported until mounted on a wall
bracket or stand. To prevent injury, use Bang &
Olufsen approved stands or wall brackets only!
When mounting the screen in a wall bracket,
leave a space of at least 10 cm (4”) at the top,
bottom and sides. Do not cover the ventilation
holes on the rear, as this may cause the screen to
overheat.
Do not attempt to open the screen. Leave such
operations to qualified service personnel!
Avoid placing the product in direct sunlight or
direct artificial light, such as a spotlight.
Do not connect any of the products in your
system to the mains, until you have connected all
the cables.
Do not leave the screen in contact with articles
containing rubber or PVC for long periods of
time.
Do not allow still pictures to be displayed on the
screen for an extended period of time, as this can
cause a permanent after-image to remain on the
screen.
The system can only be switched off completely
by disconnecting it from the wall socket.