Edirol 4-CHANNEL V-4 - Manual (Page 6)

6
Installation of Video Fader
911
• Do not touch any of the printed circuit pathways or
connection terminals.
911(F)
(French)
• Ne pas toucher aux circuits imprimés ou aux connecteurs.
913
• When circuit board installation is complete, double-check
your work.
913(F)
(French)
• Quand l’installation de la carte de circuits imprimés est
terminée, revérifiez si tout est bien installé.
927
* In some cases, depending on the environment in which
the unit is installed, the surface of the panel may
sometimes feel rough and grainy. This is due to an infini-
tesimal electrical charge, which is absolutely harmless.
However, if you are concerned about this, connect the
ground terminal (see figure on p. 16) with an external
ground. When the unit is grounded, a slight noise may
appear, depending on the particulars of your installation.
If you are unsure of the connection method, contact the
nearest Roland/Edirol Service Center, or an authorized
Roland/Edirol distributor, as listed on the “Information”
page.
Unsuitable places for connection
- Water pipes (may result in shock or electrocution)
- Gas pipes (may result in fire or explosion)
- Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
About turning the power on
941
• Once the connections have been completed (p. 17), turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to other devices.
942
• This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
the unit will operate normally.
About specifications
962a
* In the interest of product improvement, the specifications
and/or appearance of this unit are subject to change
without prior notice.
Other important notes
985
• The explanations in this manual include illustrations that
depict what should typically be shown by the display.
Note, however, that your unit may incorporate a newer,
enhanced version of the system (e.g., includes newer
software), so what you actually see in the display may not
always match what appears in the manual.
988
• Security Slot ( )
http://www.kensington.com/
• This product is compatible with regular NTSC or PAL
video signal. In case irregular signal is input, it may
obstruct stabile operation of this product.
• It is possible on this product to create video sequence with
extremely quick switching or ON/OFF of effects.
Depending on your physical conditions, such video
sequence may cause medical problem like headache etc. It
is prohibited to create video sequence that may cause such
problem. Roland or Edirol is not responsible to any
medical problem of yourselves or audiences/spectators
caused by such video sequence.
V-4_e.book 6 ページ ２０１０年３月１１日 木曜日 午後１時５１分