Bang & Olufsen BeoVision Avant - User Guide - Manual (Page 45)

45
>> Loudspeaker setup – surround sound
Adjust distances and levels automatically …
Place the connected
microphone in the primary
listening position for the current
speaker group
Upon auto detection of the
microphone, select
MICROPHONE CALIBRATION*
1
Press to begin the calibration
Select YES, if you wish to
measure for an additional
listening position for the
speaker group and repeat the
procedure
1 *In the pop-up menu, you can also choose
to create a new speaker group, optimise
another speaker group than the current,
configure speaker connections or do nothing.
Follow on-screen instructions.
You can also access the MICROPHONE
CALIBRATION menu if you press MENU and
select SETUP, SOUND, SPEAKER GROUP
and then select a speaker group.
It is recommended that background noise is
kept to a minimum during calibration.
Set distances and levels through a setup
wizard …
Place the connected
microphone in the primary
listening position for the current
speaker group
Select a speaker group in the
SPEAKER GROUPS menu and
bring it up
Select SETUP WIZARD and
bring up the wizard function
A confirmation message is
shown. Select YES and start
automatic setting of distances
and levels, or NO to cancel the
wizard function. You can repeat
the measuring for an additional
listening position for the
speaker group if desired
Press when the calibration has
completed
Also roles for internal speakers and a
subwoofer are set up through the setup
wizard.
When you confirm a calibration or a setup
wizard procedure, any previous settings for a
speaker group are deleted.
For information about connection of the
calibration microphone,
see page 16 .
A calibration microphone is available from
your retailer.