LeMond RevMaster Classic - Manual (Page 22)

Page 16
PARTS REMOVAL AND REPLACEMENT
BELT
1. Remove the front cover.
2. Loosen the shoulder bolt with
an adjustable wrench.
3. Use the allen wrench to loosen
the belt tensioner screw located
on top of the idler tension
bearings.
4. You will need a rubber coated
wrench (or similar tool) for this
next step. Position the rubber coated end of the tool between the
frame and the belt. Slowly rotate the pedals forward and pull the belt
off the front and back pulleys.
5. Install the new belt by reversing steps 1-4.
BOTTOM BRACKET
BEARINGS
I. Remove each Crank Arm.
2. Use an 8-mm hex key to
remove the pedal crank bolt.
3. Thread a bicycle crank arm
puller onto the crank arm shaft.
4. As you tighten the crank arm
puller on the shaft, the crank
arm will pull off the crank arm shaft. Remove the crank arm from the
frame.
5. Loosen the lock ring on the left side of the bike using a lock ring
removal tool.
6. Ensure that the right bearing cup
is tight. If necessary, tighten
with the bottom bracket tool.
Note: the right bearing cup is
reverse threaded!
7. Check the left bearing cup. If
the bearing cup is loose, tighten
with your fingers. Use the
bottom bracket tool to tighten
Shoulder bolt
Belt Tensioner Screw