LeMond RevMaster Pro - Manual (Page 9)

POST BEARING W/ ADHESIVE
Step 3 – Install new post bearing
Put new post bearing in aligning the tabs. Press bearing with adhesive against inside wall to secure in place.
Step 4 – Reassemble
Put parts back together clamp force should be set from before but if needed follow
(Steps 1-4 will be the same for both the seat and the handlebar post bearings)
Put parts back together, clamp force should be set from before but if needed, follow
instructions on pages 4-5.
Document # 300142
Revision 01
07/22/2008
Page 9