Lanner LEC-3010 - Manual (Page 8)

6
Introduction
Chapter 2
Embedded and Industrial Computing
Connecting Power
Connect the LEC-3010 to a 12~36 VDC power source The
power source comes from the AC/DC Adapter through a
Phoenix contact This power socket is specially designed
to guard against fault in power contact, i e , the reverse of
the electrical polarity will not damage the system
- +
Installing the Hard Disk
The system can accommodate one Serial-ATA disks Follow
these steps to install a hard disk into the LEC-3010:
Take off the top cover 1
Place hard disk inside the top cover and align the 2
holes of the hard disk with the mounting holes on the
cover
Secure the hard disk with 4 mounting screws from the
3
outside of the cover (use the long screws)
Plug the Serial-ATA cable to the hard disk
4
Connect the Serial-ATA power and data cables to the 5
connectors on the motherboard