Lanner LEC-3000A - Manual (Page 7)

5
Introduction
Chapter 2
Embedded and Industrial Computing
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server The front panel Power On/Standby button
does not completely shut off system power
Portions of the power supply and some internal
circuitry remain active until AC power is removed
Unpower the LEC-3000A and remove the power cord 1
Unscrew the 4 threaded screws from the top cover of 2
the LEC-3000A System
Slide the cover backwards and open the cover
3
upwards
Installing the System Memory
The motherboard supports DDR2 memory that features
data transfer rates of 667 MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications It comes with one Double Data
Rate(DDR2) Small Outline Dual Inline Memory Module
(SO-DIMM) socket
Align the memory module’s cutout with the SO-DIMM 1
socket’s notch
Install the SO-DIMM
2
Cutout
Notch
Note:
SO-DIMMs installed should meet the required 1
speed which is 667 MHz Do not install SO-DIMM
supporting different speeds
The motherboards can support up to 2 GB 2
memory capacity in maximum
Installing a CompactFlash Card
LEC-3000A provides one CompactFlash slot(CF1) Follow
the procedures bellow for installing a CompactFlash card
Unscrew the thumbscrews on the CF slot to take out 1
the front cover
Align CompactFlash and the card slot with the arrow
2
on the CompactFlash pointing toward the connector
Insert the CompactFlash into the connector
3
Close the cover and fasten it with thumb screws to 4
the slot
1
2 3
4