Lanner MR-320 - Manual (Page 7)

4
Introduction
Chapter 1
Network Application Platforms
Rear Panel Features
R1 R2 R4
R6 R3
R5
R1 Power Adapter socket
It requires a DC 12V/2A power input. Only use the power adapter supplied with the MR-320 System.
R2 Reset Switch
It is a hardware reset switch. Use a pointed object to press it 5 seconds then release it to reset the system without
turning off the power.
R3 RS-232 COM Port:
It requires a DB-9 Male Connector. Using suitable RS-232 cable, you can connect an appropriate device, for example, a
terminal console for diagnostics.
Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop bit , no flow control.
R4 USB 2.0 Ports
It connects to any USB devices, for example, a flash drive. Besides this external USB port, there is another one offered
with the onboard pin header connectors (refer to Jumper Setting on Chapter 3 Motherboard Information)
R5 4 Ethernet LAN Port switch module (From left to right: LAN1 to LAN4)
Using suitable RJ-45 cable, you can connect MR-320 System to a computer, or to any other piece of equipment that has
an Ethernet connection such as a hub or a switch.
R6 Gigabit WAN Port1(Left) and Port2(Right)
These two ports can be utilized for broadband connection to connect the device to an Internet service. Since the GbE-1
and GbE-2 ports are separate from the above mentioned switch module, implementation of routing is required for the
LAN ports on the switch (R5) to connect the Internet.