Lanner 1U Rack Mount - Manual (Page 7)

Software User Manual Version 2.0
5
Chapter 3. Rail Mount Installation
3.1 Separating the inner rail from the outer rail
To install the inner rail, separate it from the middle rail first. Use the following procedures:
1. Place the rail as shown below.
2. Press the safety lock tab and pull the inner rail from the middle rail until they
completely separate.
3.2 Attaching the inner rails to the system
Use the following procedures to attach the inner rails to the chassis.
1. Position the inner rail adjacent to one side of the system’s chassis. Make sure that
the safety lock tab faces out, and that the notched end of the rail is located at the
rear of the unit as shown in the following diagram.
Safety lock tab
Inner rail
Safety lock Center rail Outer rail