Echo PB-2400 - Manual (Page 11)

11
P
OWER
B
LOWER
O
PERATOR
'
S
M
ANUAL
A
SSEMBLY
WARNING DANGER
Never perform maintenance or assembly procedures with
engine running or serious personal injury may result.
INSTALL BLOWER PIPES
1. Align grooves in straight pipe with pegs on blower housing and
slide pipe onto housing.
2. Turn straight pipe clockwise to lock it into place.
* Certain internal combustion engines operated in forest, brush and/or grass-covered areas in Washington, Oregon,
Idaho, California, Minnesota, New Jersey and Maine must be equipped with a spark arrestor. This requirement also
applies to all U.S. Forest Service lands. In some of these areas, the spark arrestor system must be certified per USDA
Forest Service regulations SAEJ335. Check with your local or state authorities for specific regulations in your area.
Failure to follow these requirements is a violation of the law.
S
PECIFICATIONS
340mm (13.4 in.) w/o blower pipe
215 mm (8.46 in.)
375 mm (14.75 in.)
4.3 kg (9.5 lb.)
Air-cooled, two-stroke, single cylinder gasoline engine
34.0 mm (1.34 in.)
26.0 mm (1.024 in.)
23.6 cc (1.44 cu. in.)
* Spark arrestor muffler
WALBRO diaphragm model WT w/purge
NGK BPM-7Y
Mixed (gasoline and oil)
50:1
89 octane unleaded. Do not use fuel containing
methyl alcohol, more than 10% ethyl alcohol or 15%
MTBE.
50:1 ECHO High Performance 2-stroke engine oil
0.5 lit. (17.0 U.S. fl. oz.)
Automatic rewind starter Centrifugal type
7300 RPM
2500 - 3000 RPM
300 cu. ft./min
150 MPH
Length
Width
Height
Type
Bore
Stroke
Displacement
Spark Plug
Fuel
Fuel/Oil Ratio
Gasoline
Oil
Fuel Tank Capacity
w/pipes
Dimensions
Weight w/pipes (dry)
Engine
Exhaust System
Carburetor
Ignition System
Fuel System
Starter System
Wide Open Throttle Speed
Idle Speed
Max Air Volume
Max Air Speed