Yaskawa Sigma-5 User Manual: Setup for Rotary Motors - Manual (Page 103)

5 Trial Operation (Checking Servomotor Operation)
5-6
6
Press the Up Cursor Key to rotate the ser-
vomotor in the forward direction and press
the Down Cursor Key to rotate it in
reverse. The servomotor will operate
while the key is being pressed. (The fac-
tory setting is 500 min
-1
.)
Confirm that the servomotor operation is
correct. At the same time, carefully
inspect the servomotor’s condition and
check the following points in particular.
If a problem is found, correct it.
• Is there any unusual vibration?
• Is there any unusual sound?
• Is the temperature rising unusually
high?
7
Press the MODE/SET Key. The servo-
motor power will be OFF.
Note:
The servomotor can be turned OFF by
pressing the DATA/SHIFT Key for
approximately one second.
8
Press the DATA/SHIFT Key for approxi-
mately one second.
"Fn002" is displayed again.
9
Press the MODE/SET Key to return to
the initial display (step 1).
(cont’d)
Step Display after operation Keys Operation
MODE/SET DATA/
Forward
rotation
Reverse
rotation
/ /
MODE/SET DATA/
/ /
MODE/SET DATA/
Alternate
display
MODE/SET DATA/