Yaskawa SmartTrac DM6420 Multi I/O Card - Manual (Page 12)

Smart Trac DM6420 Multi I/O Card
8
••
Installing the Smart Trac DM6420 Multi I/O Card Technical Manual
NOTE: If replacing or adding a Smart Trac DM6420 Multi I/O card to an
existing Smart Trac card stack, see "Appendix C – Removing the Smart Trac
Card Stack" before continuing.
Trac
2CN
Connector
4CN
Connector
CPU
Card
PS Card
Ethernet
Card
Adapter
Ring
Card
PC/104
Optional
Smart Trac
Multi I/O
Card
Smart Trac
Smart Trac
Smart Trac
PG Card
Smart
Card
Inverter Control
Main Chassis
Standoffs (4
places on top of
each card)
Figure 2. Smart Trac Multi-I/O Card Stack Position
1. To install the Multi I/O card, orient the pins on the card with the female
pin connector on the card below it (normally the Ethernet card). Gently
but firmly push the Smart Trac DM6420 Multi I/O card onto the card
below it. Make sure connecting pins are in alignment before pushing
the two boards tightly together. Secure the card using four (4) metal
standoffs.